Cozy blankets, a cup of chocolate milk, and the favorite book or movie, how else can you define the perfectly snuggly winters? However, if you find that your water heater has stopped working, the entire scenario can turn upside down. Without any doubt, you will take out your phone and type service providers for the water heater in Pittsburgh if that’s where you live. Yet, do you want to get into a situation where you will have to step out of that comfy mode? Do you? Before you find yourself in a situation like this, it would be wise to ensure the apt care for your water heater. Keep reading if you are wondering how to do that!
Choose the Apt Temperature
Yes, everyone can have their preference with temperatures! However, do you know when you adjust your thermostat beyond 120 degrees, more and more minerals settle down and lead to the formation of deposits? That is not good for your water heater, which is why you must keep the geyser in the zone.
Apart from this, for every 10 degrees you lessen, you can expect a saving of nearly 5 percent on your expenses. Also, if you go out for some days, you can set the thermostat for gas water heaters on vacation mode. That would maintain the pilot light even without having you heat the water.
Drain the Water Heater Tank
Flushing the water heater tank is essential for water heater care. It can improve the quality of water coming to your home, but this is not all. It can save you big bucks as you will not have to spend on repair and re-installment. Coming to how to do that, you can begin by switching off the heater and then closing the valves that supply cold water.
After this, attach a hose with the drain valve. The next step includes opening the handles of the faucet and emptying the tank. Later on, shut the drain valve and cut the hose. Next, open the supply for cold water; after which you must open the faucets of hot water across the home at once. Wait to restore the power until the entire water has flowed out.
Keeping an Eye on the Anode Rod
Anode rod refers to the long metal rod responsible for attracting and removing corrosive minerals from the system. It is no longer functional if it has corroded too much, and that is when you must get rid of it. Are you wondering how to do that? First of all, put a hose at the drain cock of the hose and let a few gallons of water go.
After this, add a 1 1/16-inch socket on the hex head of the rod on the heater’s top, and that is how you can screw out the rod. Replace it if you find it corroded/ coated with calcium or of radius less than that.
Insulating the Water Heater
Do you know that the insulation of a water heater can lessen the heat loss by up to 25 to 45 percent? As a result, this can bring you savings up to 7 to 16 percent. Also, you can do it on your own without having to call any plumber! Okay, now let’s get started with how to do that!
For this, you must cut the insulation blanket to fit or surround the pipes, TPR valve, along with the temperature control coming out of the tank. After this, you must wrap the tanks and seal cuts, if any. Make sure not to cover the top of the gas or oil heater. For an electric heater, cover it with the oversize insulation circle and set the edges to secure the sides.
There are times we overlook it, but little things like a functional water heater can make a huge impact. Similarly, the efforts you make for it to run normally can save from the costs of repair, reduce utility bills, and repairs.
For the water heater care, don’t increase the temperature beyond 120 degrees. Remember to insulate the water heater, check the anode rod, and flush the water heater twice a year. If you find the processes hard to perform or the situations being more critical. Remember, you can always reach up to the professionals for that. All you need to do is type plumbers in Franklin Park if that is where you live.